Hot Work Fire Watch in Tacoma: 6 Rules Before You Weld or Cut
Short answer: Tacoma lists hot work among its operational permits, and its hot work permit calls for a fire watch during the work and at least 30 minutes after. OSHA and NFPA 51B add their own triggers and watch times; follow the strictest one that applies.
1. Check the permit first
Tacoma Fire Department lists hot work among its operational permits. Confirm with TFD Fire Prevention, and with the facility, before work starts.
2. Know when OSHA requires a fire watcher
Under OSHA 29 CFR 1910.252, a fire watcher is required where more than a minor fire could develop, for example appreciable combustibles within 35 feet of the work, or wall and floor openings within 35 feet that expose combustibles.
3. Move combustibles or guard the other side
Relocate combustibles at least 35 feet away where practical. Where they stay, post a fire watch on the opposite side of walls, floors, and partitions.
4. Equip and train the watcher
The fire watcher keeps an extinguisher ready, knows how to sound the alarm, watches all exposed areas, and only fights a fire clearly within the capacity of the equipment.
5. Stay after the work ends
Tacoma鈥檚 permit and OSHA call for at least 30 minutes after hot work. NFPA 51B (2019 edition and later) calls for at least one hour, plus up to three more hours of monitoring if the permit authorizer requires it.
6. Make fire watch the only job
The welder cannot watch every exposed area while working. Assign a dedicated watcher with a phone or radio. In Washington, workplace safety rules are enforced by L&I, so confirm which rule your safety lead follows.
Sources: Tacoma Fire Department, Fire Prevention 路 OSHA 29 CFR 1910.252 路 NFPA 51B
More guides: Warehouse Sprinkler Shutdown in Tacoma: 6-Step Impairment Plan